IBest

IBest 2.23 inch OLED Display Hat for Raspberry Pi/Jetson Nano/Arduino 128×32 Pixels SPI OLED I2C Display with SSD1305 Driver

Condividi:

  • 2.23inch OLED display HAT with embedded SSD1305 driver ,SPI/I2C interface
  • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
  • Optional interfaces: SPI (default), or I2C, configured via onboard resistor
  • Brings control pins for host boards like Arduino/STM32
  • Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)

Overview This is a 2.23inch OLED display within controller.You can directly add it on Raspberry Pi by the 40 PIN pinheader, or connect it to other hardware platform via the IIC and SPI interfaces.The interface of 2.23inch OLED HAT is default SPI, you can also switch to I2C by soldering the resitors on the back of OLED.

Trying to add a control interface for your Pi? This compact display would be the ideal choice. Specifications Driver: SSD1305 Interface: SPI / I2C Display size: 2.23inch diagonal Display color: white Resolution: 128×32 Viewing angle: >160° Power supply voltage: 3.3V/5V Logic level: 3.3V Interface VCC:3V3/5V–Power input GND:GND–Ground DIN:MOSI–SPI data input CLK:SCLK–SPI clock input CS:CE0–Chip selection, low active DC:P24–Data/Command selection (high for data, low for command) RST:P25–Reset, low active Development Resources Wiki :www.waveshare.com/wiki/2.23inch_OLED_HAT?Amazon Package Content 2.23inch OLED HAT x1 RPi screws pack (2pcs) x1 Note: More information you may need , please check the wiki or contact with us first.

Storico del prezzo su Amazon

30gg. fa Oggi

Prodotti correlati

Dal nostro magazine

I top brand di Prezzo.it